Recent content by iCloud

  1. I

    Gx200 clone kicking / hiccup?

    That sounds familiar as the plug is black and if I put the fuel about 2mm switched on it runs just fine at idle and about 1800 rpms then just fuel starves
  2. I

    Gx200 clone kicking / hiccup?

    I couldn't or didn't want to remove the flywheel as I don't have a torque wrench and I only have a ratchet big enough and I don't want to break it but the guy I bought it if said it has a new one anyway so I wasn't to worried
  3. I

    Gx200 clone kicking / hiccup?

    I had the head compleatly apart and replaced the springs and it's still doing it, I checked the valves and sealing surfaces and they are all good the top of the cylinder head is black though even after I cleaned it but the piston is clean on top, the new plug is very black which I think means...
  4. I

    Gx200 clone kicking / hiccup?

    I took the valves out and they could use lapping but I'll try that now !
  5. I

    Gx200 clone kicking / hiccup?

    Replaced all of the electrical wires and set the air gap
  6. I

    Gx200 clone kicking / hiccup?

    Hi first post and as always not to sure if this is the right place but I've had an idea for a go kart of my own for a while so I bought a gx200 clone with a faulty carb of ebay.... That's how it started or didn't start in my case so I'll cut to the chase I've replaced almost everything part from...
Top