Recent content by iatemeself

  1. I

    what is this?

    what do you mean by larger diamiter roller wheel and out of all those motormounts which would do the job for a predator 212cc ALSO im using a wire wheel on a drill and its taking a lot of the rust off really quick, going to take off the engine and clean up the rust from the frame
  2. I

    14cc 18cc or 22cc head what is this?

    what is this? I have a spare engine laying around I think its a 5.5hp so it should be a 14cc head from a gx160... Was wondering as well if the stud kit from the predator would work on this cylinder head because the valve studs were stripped on this cylinder head... I'm going to slap this...
  3. I

    what is this?

    Thanks a lot for all the helpful info :thumbsup: it seems like i would have to move the brake setup and get a different seat in order to fix the 2nd engine?
  4. I

    what is this?

    sweet that's some good news, do you know if the master cylinder hydraulic brake kit would slap on this? how would I set it up for dual clones? is this a good find for 300?
  5. I

    what is this?

    thanks man just took it for a spin last night the ground was slightly wet and boy was it fun i was drifting around all over the place lol :drool5: anyone got any tips on how to remove the rust from the axle, brakes, and steering components without damaging them? The brakes work well, however i...
  6. I

    what is this?

    Just picked up this go kart frame and slapped on a harbor freight 212cc on it, just order k&n dirt filter and adapter, candy cane header stage 3, got a gx140 emulsion tube and a 90 main jet, going to strip the frame and paint it red, remove the governor internally and install 18lb valve...
  7. I

    what kind of margay is this?

    Also there is no setup for throttle or brakes on the go kart and was wondering how they were set up if anyone had pictures it'll be greatly appreciated
  8. I

    what kind of margay is this?

    i have searched the frame up and down and even checked for a serial on the spindle and I can not find any serial... the front axles do have "margay" printed on them though is there any measurements that I can take in order to find out what brake system I can get? I need the caliper and unsure if...
  9. I

    what kind of margay is this?

    thanks my axle measures 1 1/4" and I need to get a sprocket hub to hold my 59 tooth sprocket... Also there is no brake set up at all but there is a disc on the live axle.. need help in finding parts for the whole brake system what is the stock margay set up look like? Where can I find an...
  10. I

    what kind of margay is this?

    just picked it up dirt cheap off craigslist needs some hardware aswell as a live axle hub ... anyone know where i can find one ? Also needs engine mounts and not too sure how these are suppose to look this ones not complete
Top