Recent content by Howitzer

I relocated this post to the general area. How do I delete a post from another area? Anyways... Anyone have any design suggestions for my DIY go kart? I bought the frame and made a few additions and improvements. My Kart: - 8 HP B & S engine - 13 x 6.00 x 5 wheels (not installed yet, old...

Can one install a 60-72 tooth sprocket? Sounds quite large... this would slow the cart down a fair bit eh?

I wonder if they are high speed bearings and tires... does the Princess Auto link say they are?

Great advice, I was starting to think the same thing. Maybe I can find these rims locally.

Yes if is keyed. 1" shaft...

Great! Any comments or advice now that you can see better what I'm talking about?

I uploaded the pics as attachments and then inserted them into my post... can you see them now?

Ok, thanks for letting me know that the photos are not visible. I have a "OneDrive" account I have been using photos from (I've used my OneDrive account pics before for other forum posts). What is the best way to post pics?

I was wondering if some type of retro-fit keyed sleeve could be made to insert into and welded to the hub.

My go kart: I just purchased these rims and wheels (13 x 5.00 x 6) for my go kart: http://www.princessauto.com/en/detail/13-x-5-00-6-turf-tire-assembly/A-p8442493e. I believe the bearing in the wheels are flange bearings (5/8" bore, 1-3/8" O.D.)... this is what they look like: How do I...

Here are some pics of my go kart: I purchased a 10-tooth Hilliard #40 chain driven clutch (from Princess Auto locally: http://www.princessauto.com/en/detail/3-4-in-10t-centrifugal-chain-clutch/A-p8300600e) for my go-kart but I'm not happy with it. My kart is powered by a 8 hp Briggs &...