Recent content by hmdballa219

For the chain are you referring to the same set up as this kart? Moving the motor wouldn't help me with the chain I don't think. It doesn't connect to the motor. And same motor the predator 212 you used a shaft extension on? Or the spacers. How and where do I buy.

Ya the chain is kind of loose, it happens on grass. On paveme t I am fine, when I go I to the grass and go balls to the wall and almost tip over is when it falls off lol. 2 times in the grass on hilly rough terrain. Never on the pavement have I had a problem. I was going to take a link out of...

Ok belt finally came, and finally got a little time after work tonight to put it on. Drives much better.very torquey, I have a 2018 mustang GT 5.0 and it makes me feel like I'm driving that almost, how much it throws u back in the seat and take off. I used the gps speedometer on my phone and...

Ok got it makes sense the mount holes would line up then. I'm about to order it. You have been a major help in pointing me in right direction. I just ordered it and when it gets here I'll post back here to tell my progress !!! Thanks again!

Man I appreciate it alot. So based on the comet 30 series I found it to be BELT 203591A. It also says for yerf dog 3203. Although it doesn't have the same engine in it, I don't know if that changes anything really? Since the TAV and drive are still the same. ---------- Post added at 12:18 PM...

Also picture of belt number for reference if needed.

There is pictures showing the slack off the belt. Thinking that's why I'm assuming? The back gear moved a little that is on the axle, enough to show it's working.

Oh wow ok, ya I was actually comparing it to a torque converter and calling it that, even tho like u said, completely different lol and Yes, I honesty think it is probably the belt too, it is very loose, but that is the best fit I could find when ordering. Had no previous belt on other set up...

Tav is torque converter? Ya the belt goes freely. But I used the same torque converter that was on it and just ordered a belt that was close enough to the size after measuring. They said it should be a little lose so I can move the kart, then when gas given it should tigthen up and take off...

Hello all, I'm extremely new to the go kart world. Bout one for cheap. It is a yerf dog 3203. Had a predator 212 motor in it, that was locked up. Put a new one in there. Got a new belt because it was broken, and some other miscellaneous things. My question is what's a normal speed for this...