Recent content by HELLSUNICORN

  1. H

    gtc torque converter problems

    Just to update this. I ended up clocking the backplate. That did not help with my problem. I ended up buying a new belt with the same part number. Once I put the new belt on on it was obvious what my problem was. The old belt had shrank or was manufactured incorrectly. It was shorter than my new...
  2. H

    gtc torque converter problems

    The chart is saying 203589a not 5959. 203589a is what I have. Am I reading the chart wrong? I am 6 3/4 distance on the shafts with a 6 inch driven. I agree my problem is the belt is to tight. I just don't know why. I think I am going to try and clock the backplate to see if it helps. The...
  3. H

    gtc torque converter problems

    Here is a picture with the driver removed. It is very tight even over the shaft.
  4. H

    gtc torque converter problems

    This is a 30 series GTC. The driven pulley measures at 6 inches outside diameter. The center to center on the shafts is 6 3/4 The belt number is 203589 According to the cart this is the belt. It is tight even without the pulley on the engine shaft.
  5. H

    gtc torque converter problems

    Thats my problem. This is the belt that it is supposed to use. It is listed as this belt on the GTC website and it came with the kit. The back plate is a solid piece of aluminum. I cannot adjust the distance between the 2 pulleys. Is it possible the belt has shrunk from sitting a few years?
  6. H

    gtc torque converter problems

    I purchased a GTC 30 series with a 1 inch driver a couple of years ago. I have finally gotten around to installing it. I am installing it on a brand new 8 hp Harbor freight engine. The problem I have is that once the engine is started the belt does not slip at all and the cart wants to go...
  7. H

    Any complete TAV kits for 13hp clone?

    What parts would I need to purchase to build the jackshaft? Who sells them? I am able to cut and weld steel so making something is not a problem. I just have so much other stuff going on I would like to do this with as little time invested as possible.
  8. H

    Any complete TAV kits for 13hp clone?

    I am putting a 13 hp clone into my go kart. It currently has a 6 hp mitsu motor and an unknown brand CVT. I am looking for a complete kit similar to the TAV 2 that I can bolt on to the engine and not have to fabricate anything. I would put the comet TAV 2 in it but I do not know if it can handle...
Top