Hellion's latest activity

Is it a brand new engine? If so, the muffler will smoke from the paint and residues left on it during manufacturing.

Finally everything is done... That was a REALLY long thrash, I think 12 hours over two days.:smiley_omg: Haven't run it yet as I have no...

I just noticed the extra large set screws, egad. ‘Can’t see the forest for the trees’, man. Anyway, that’s a 10/10 lesson there on...

The easy way for me to tell looking at a clutch from the front is the snap ring holding the drum on the sleeve. The snap ring we use...

These count, albeit the size parameter might be lacking: https://www.lucaspowersports.com/ The ‘55 Chevy Taskforce is quintessential...

The washer is the same age. I honestly don't think it's ever been worked on. When the repair guy worked on the dryer he said " if it...

This thread is about the quality (materials & manufacturing) of the genuine Comet belts vs. them Chinesium belts...right?? So, just for...

It really is something to hope for but I worry that we (the USA) may be out of "come backs".

The Whirlpool World HQ's ...& factories are right here in Lima Ohio...USA :2guns: It seems like some folks (mostly China but, some...

Tell us more about your skill level and your lot in life. :cornut: ”Maybe build” is such weak, uncertain language. We want to hear...

Still waiting for new cdi to be delivered

Ok I got it to “idle” but it’s pretty awful. It will only somewhat stay running with the screw pretty much all the way out and id guess...

I had an old tether drag car when I was a kid. Even though it just went in a circle, it hauled a$$ and man would I get dizzy! 😂

That is so cool! When I was a kid I could run mine for hours without getting bored. The school by my house even had a gas powered car club.

Fine work, Makisupa. The jackshaft provides, I think, the low end grunt that a normal two sprocket setup can’t provide, so it’s more fun...