threw the cardboard sleeve away.... I think the belt he sold me is too short. When idling, the driven pulley closes up and pushes the belt out to the edge...when that happens, it's pulling the belt tight against the engine drive shaft... as I said in the original post....driven pulley is 6" in...
it appears that the driven pulley is closing up to the point that it forces the belt way out near the outer edge which is pulling the belt tight against the engine shaft where the clutch is
I saw your other post but I'm a little confused as to how I would figure out the cross referenced number.... I don't think the belt from the L&G shop was even the right belt... it looked square to me... he just tried to find one the same length as the torn up one that came off of it. He didn't...
I replaced the belt on our kart with one from a local lawn & garden shop. However, now the kart wants to move forward even when the throttle isn't being pushed. The manufacturers site doesn't give any "specs" on the belt and I was hoping to find one locally. The driven pulley is 6" in diameter...
I just bought my boys a Vector 4170 with a 6 hp Subaru engine. I had to put a new belt on it, but after a little while the belt started making a little bit of noise and the kart wanted to move forward even when the throttle wasn't being pushed. I took the belt cover back off and it appeared the...