Recent content by FlamingChicken

I was thinking wire brush, but wasn't sure if it would be too abrasive. Didn't know if there were any tricks/special tools too use. I'll just see what I can do. Thanks for all of the help guys!

OK guys, pulled the carb and this is what it looks like: What is the best method for cleaning these carbs?

I'm trying to get this motor running for a friend. It will run if I drizzle gas down the carb, but it won't pick up the fuel from the tank. The only thing that I see is strange, is that it is missing that metal tube that goes from the carb to the engine. The carb side is 'capped' off, but the...

Maybe you can explain this to me. I'm just building a basic frame, one wheel drive, 15" tires, 66t sprocket, and a 12t clutch. It will be driven on flat ground and I weigh about 150lbs. Do you think I will be in danger of over-revving?

Hello all, I would like to use the HF 13hp engine for my gokart build, and I'm wondering how to allow more RPM (ideally around 4600) without completely removing the governor? Or do I remove the governor and install some sort of rev limiter? I guess the bottom line is: I want more RPM without...