Recent content by bradwsm

I wish. I cut all the aluminum with a Ryobi jig saw.

Haha! I wish I had a shop! Doing it on the plywood in front of the shed and on the side of my house on a saw horse with 2x2 plywood top! All angle grinder and hand drill. You would not be envious of my working conditions! Left half done!

Here is the finished steering hoops. Little tabs are for the gauges

Top deck and floor on. Finishing steering hoops tomorrow.

Thank you, if only you were in Florida!

Another ultra high quality YouTube video!

Thank you! That's it! 15 yrs ago or so I use to tinker with motorcycles. It's something I always wanted to do and I am glad I did, it's so much fun!

Here is one pic of the main pieces put together. It was late, 1 million degrees, and bad light will post better pics soon.

Rear frame mount /gas tank holder / seat frame built, needs to be scrubbed, painted and wrapped in aluminum. Both fronts on and sway bar mounted. Roll hoop/ rear link mount built.

I had to make changes to the input location but here's the gist.

Will do! At this point it's way lighter than the 312 was!

Front left on.

Drew the plans and made the main frame sections. Need to layout all the detail part out now