Recent content by Bph30-06

More

More pics

Pic 2

Here is a upload picture of the driven. It now has the reverse wound yellow spring in it.

Ok well I should have took pics when I had it apart. But the reason it was so hard to get off was they had loc tight from factory on it. I'll get some pictures of it up close when I get home tonight. For a simple pulley they sure are expensive.

Thanks guys yeah I guess I'm gonna take it to work tomorrow maintenance shop I hsve a lot more tools there to work with and I'll see what I can do there. We got some 48" pipe wrenches there if that don't work I'm gonna be lost lol. But the spring is loose now that I took the buttons off. I'll...

Ok guys I got the cam buttons out but now I can't break the outter can loose on the threads and yes I'm turning the correct way. Does anyone know if these are loc tighted on the threads?

Yeah man looks like you ran into same problem. Have you got your cart runnin yet after putting that tc on?? If so how's it run and what size engine you running?

Yeah it's bout 2 inches difference. But I have already made my jack shaft plate and all so trying to continue forward in progress and not go back to drawing board. Plus don't have much room with way I made read frame to clear chain to axle. Thanks I'll try tomorrow to get the spring changed out.

Thanks. So your saying remove the buttons to be able to spin off plate. How do they come out? And reason is I have built my own frame with intentions of makeing my own clutch system like lawn mowers but decided to do it right and not rig it. And I bought the belt for my center distance before I...

Ok I called a supplier and did more research and it is reversible but you have to swap out red spring with the reverse wound yellow spring. I have one now just need to figure out correct way to separate pulley

Hey guys I got a comet 44 series driven unit. And I nee to install the yellow reverse wound spring. Need to know how to take apart and put new spring in. From what I see is I need to lock the pulley on the shaft and spin outter sheave to relieve pressure and use a spanner wrench and break loose...

Hey guys i new some help with driven pulley. 44series comet. From all the pictures I've seen on websites and paperwork that came with it the driven is installed with spring side toward engine and flat side out. Does anyone for certain know if that is correct or Is it reversible.

Yeah I agree with the front suspension I'm thinking of makin a arms for it but right now I just wanna drive it bad. Been working on it since last winter when I got the motor. And the engine is a few inches forward over center of axle. Not sure how much farther I can go with out redoing the rear...

Yeah but can't complain to much I got the engine for free from a buddy. He didn't think I could get it running.