Predator 212 flywheel won't go back on

Swagdaddy

New member
Messages
3
Reaction score
2
I removed the stock flywheel in order to install a power start kit and I can not get the stupid flubbing flywheel to slide on far enough. Here's the kicker - the original stock flywheel is doing the same stupid bull crap. I am very mechanically capable, but I can not figure out wtf is happening. Any ideas? Thanks in advance
 

karl

Well-known member
Messages
2,449
Reaction score
719
Location
North east Ohio
If you have not already, remove the ignition coil to help line it up.

The woodruff keys can be kinda tight, make sure there is no burrs or scratches on it,
may want to remove the key, clean it up with some emery cloth, clean the crank and flywheel
up nice n clean, and retry.
 

Swagdaddy

New member
Messages
3
Reaction score
2
I did move the ignition coil out of the way and cleaned the key up w some 220 grit... Stupid thing still won't seat fully.
 

karl

Well-known member
Messages
2,449
Reaction score
719
Location
North east Ohio
Gotcha, was this kit intended for a predator, or just a universal kit?

The hemi taper is way bigger than gx200/clone, and the non -hemi is just
slightly different, enough to cause problems .

One more thought, did you try removing the charge coils, and see if either flywheel fits?
Could be an interference there.
 

Swagdaddy

New member
Messages
3
Reaction score
2
Karl - thank you so much for all of your help and suggestions. I feel like a dumb azz... The starter geared flywheel came off of an Amazon Honda clone and everything appeared to be identical... Except for the flywheel taper was 0.2 c¥πt hairs smaller than the Predator.

I was bummed out initially, however after some thought, it's a win overall. Never too old to learn that you don't know everything and that the obvious stuff is easily overlooked. Also, finding this forum and its helpful members is a definite win. Cheers mate. All the best!
 
Top