Deckin' Blocks

Status
Not open for further replies.

MonsterBike

New member
Messages
30
Reaction score
0
Location
around Ft. Wayne Indiana
Last few days of school :wai: and I decided to Mill some off of the head and block on my 5 hp flathead Briggs on the Monster bike in my machine trades class. Any recommendations on how much to take off? Also ideas for fuel. Soon I will be trading a minibike for a chopper minibike w/o a motor perhaps another hot 5hp Briggs will be in the works.
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
if you deck the block, i have heard that you should rebore/hone the cylinder as it may make it out of round.

Why deck the block when you can just get a thin copper headgasket?
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
Just look at the difference between the stock head gasket and a copper one. .050" vs ~.030? Also measure the top dead center height of piston from the center of piston, vs the top of the block. You don't want to mill too much off, but can mill enough to make piston flush w/top of block I have heard. Also, if you mill too much, or anything for that matter...you will reduce flow and will need to shsve eyebrows. Also you will need to check valves to make sure they don't contact the head.
 

Joe-405

Enjoying New Projects
Messages
2,673
Reaction score
98
Location
U.S.A.
I was told to never cut a head more than 30 thousandths or else you will loose power. The engine needs more air to move and you loose all of your air flow to the valves from the piston area cause of the design.
 

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,866
Location
Chicago-town USA
I was told to never cut a head more than 30 thousandths or else you will loose power. The engine needs more air to move and you loose all of your air flow to the valves from the piston area cause of the design.

The thread in the link above says the same about the head. Not sure about the block?
 
Status
Not open for further replies.
Top