Torque converter questions???

[Speedknot]

I'm looking to put a TAV2 30 on my Coyote. Does anyone have the measurement from the crank case to the end of the shaft bolt? I need to see how far the pulley sticks out from the engine. Might have a clearance issue with the seat.
Also. How do I figure out what size sprockets I need to run?

 

[Half-breeder]

I'm looking to put a TAV2 30 on my Coyote.

Hmmm didnt know those wild dogs had mounting holes... normally a TAV2 is installed on an engine... but then again Ive never inspected that species of K9 before... (hint: pretend we dont know who/what you have in EACH new post).

Does anyone have the measurement from the crank case to the end of the shaft bolt? I need to see how far the pulley sticks out from the engine. Might have a clearance issue with the seat.

Well... the distance that the "Driver" sticks out from the engine/shaft, will usually depend upon alignment of the pulleys and sometimes engine/shaft type.

Also. How do I figure out what size sprockets I need to run?

Depends on engines abilities and desired topspeed. The way I figured my own desired gearing was I watch a vid... did the math... used a speed calculator.
https://www.youtube.com/watch?v=J1HlMCnW7Pg

 

[Speedknot]

Thanks Halfbreed

 

[Poboy kartman]

It's always best to just continue a thread if it's the same kart....even if it's a different problem....