Liddle Rip... Who dat?!

[JermDawg]

I've looked akerman up... But if it my problem were truly ackerman, wouldn't it have the same error turning both ways? Because it only makes noise at a left turn. I fixed the alignment. The wheels are now measured at 37" apart front and back. (Perfectly, though I still need to run it again.)
I've also gone and bought a carb rebuild kit. It'll probably come later in the week.
My battery is also dead... when it rains, it pours, right? So I'm unable to see if the noise is still there when I turn.

 

[JermDawg]

I'm back with news! I got the carb rebuild kit!
I've never been really good at finding stuff online, though I did look, and came up with nothing, but perchance could someone link me to a DIY thread or site that show/tells how to use a carb re-build kit?

 

[JermDawg]

Update: Turning left still makes noise.
Still runs rich, and rougher than before, but when I floor it, THE GUY GOES! (Actually pulled a three wheeler... =P) It doesn't idle without throttle now. =(
Suggestions?

 

[Half-breeder]

"sounds like" fuel/air. Idle adjestment is either off... Then again (chances r slim), suppose it 'could' be your timeing... But not sure. If carb is straight, n i runs when opened up... seems like your fire is off. Then again sorta sounds like fuel filter probs too... Hmm im just throwing out possibilites.

 

[JermDawg]

"sounds like" fuel/air. Idle adjestment is either off... Then again (chances r slim), suppose it 'could' be your timeing... But not sure. If carb is straight, n i runs when opened up... seems like your fire is off. Then again sorta sounds like fuel filter probs too... Hmm im just throwing out possibilites.

Thanks Half!

I actually just bought a new carb. We still can't figure out how the hook the 'hoses' up. If someone is willing to post a pic of how theirs is configured, that would be amazing!
Looking forward to modding this liddle guy. =)