clutch/gear/chain switch

Status
Not open for further replies.

fasteddie

New member
Messages
12
Reaction score
0
hello everyone, great site!
well the kids did a good one on my clutch, (blowing it up) and bent the gear on the rear axle. i have a 5hp briggs with a 3/4 shaft, a 10 tooth clutch and a 420 chain. should i think about switching over to a #35 chain? why is there different chains? where is the best place for prices?

I was looking for parts and i found a two seater 6hp ohv tecumseh dingo for 200 bucks. it wont idle but the kids have been riding the hell out of it today. now my repair projects will double, lol
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
...bent the gear on the rear axle

How on gods green earth did they manage that?


I was looking for parts and i found a two seater 6hp ohv tecumseh dingo for 200 bucks. it wont idle but the kids have been riding the hell out of it today. now my repair projects will double, lol

Pics please... Sounds like a good score, idling problem should be an easy fix; have you cleaned the carb yet?
 

fasteddie

New member
Messages
12
Reaction score
0
The kids say they hit a large rock and they stalled the cart . So i have a 60 tooth gear and thinking aboit going down to a 54 . I will take pics tomorrow..... I have only had the dingo for less than 24 hours now and the kids won't get off of it.
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
The kids say they hit a large rock and they stalled the cart . So i have a 60 tooth gear and thinking aboit going down to a 54 . I will take pics tomorrow..... I have only had the dingo for less than 24 hours now and the kids won't get off of it.

I would not go down to a 54T sprocket. If you have a 10T clutch, this will mean that you will have a gear ratio of 5.4:1. This is a bit high, and you might be frying your clutch quite fast. What diameter tyres do you have
 

fasteddie

New member
Messages
12
Reaction score
0
Lol, the kids can't reach the gas pedal so for a fast fix I duck taped a 4 x 4 block to the pedal.
 
Status
Not open for further replies.
Top