hoping for a little help

Status
Not open for further replies.

FatCat

2 stroke Addict!
Messages
459
Reaction score
3
Location
Ottawa, IL
Every engine ever built will create a carbon build up in the combustion chamber; removing it is healthy. Letting it build up excessively creates "hot spots" which causes pereignition.

I've read of people polishing the piston with super fine sand paper to help keep away the carbon buildup. Have you had any experience with this? I read it somewhere but can't remember where. Seemed like an interesting idea to me.
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
I've read of people polishing the piston with super fine sand paper to help keep away the carbon buildup. Have you had any experience with this? I read it somewhere but can't remember where. Seemed like an interesting idea to me.

TBH, no, I haven't but, as you said, it sounds like an interesting idea.

Just to clarify; hot spots take years, decades to build up.

I do remember one story where someone had a preignition problem on an old Holden red 6 (I6 engine) so he took off the head (just the head, nothing else) &, using a wire wheel, polished away every morsal of carbon on the head & the pistons; he even got a feeler guage down the side of the crown, which turned out to be his downfall.

When he put the head back on the engine wouldn't start. A compression test showed nothing. No, I mean nothing, no compression. The carbon was acting as a seal for the worn rings & valves & removing it opened everything up. Needless to say, it cost him a reconditioned engine.

Sorry about that, hope you enjoy it...
 
Status
Not open for further replies.
Top