Crankshaft End Play 6.5 Clone

Status
Not open for further replies.
Messages
15
Reaction score
0
I am doing a Hop Up on a 6.5 Clone and need the Crankshaft End Play Spec. The End Play is currently 0.017. I am using a Billet Side Cover with an O-ring. I have shims for the crank: 0.02, 0.05 and 0.06X2. I also have Gaskets for the Side Cover that are 0.019. So I have many options to use to get where it needs to be.
I build and blueprint race motors for cars but small engines are a change but I love the simplicity of them, and the fact that I can do it in my office on the desk in the a/c ! LOL

Any advise would be welcome.

Thanks
Reaper
 
Messages
15
Reaction score
0
Got my answer

I am doing a Hop Up on a 6.5 Clone and need the Crankshaft End Play Spec. The End Play is currently 0.017. I am using a Billet Side Cover with an O-ring. I have shims for the crank: 0.02, 0.05 and 0.06X2. I also have Gaskets for the Side Cover that are 0.019. So I have many options to use to get where it needs to be.
I build and blueprint race motors for cars but small engines are a change but I love the simplicity of them, and the fact that I can do it in my office on the desk in the a/c ! LOL

Any advise would be welcome.

Thanks
Reaper
I just got my answer from Russell at NR Racing. He stated that the end play should be .005 -.007. Hope this helps someone else out there.
 
Status
Not open for further replies.
Top