Centrifugal clutch options

Status
Not open for further replies.

oldfart

New member
Messages
1
Reaction score
0
I'm needing a new clutch for my mini bike. 5.5 HP Honda. It had an entry level Max Torque on it. Seemed a bit grabby at the engagement point. I'm also considering a Hillard Extreme Duty 3435 that claims to absorb heat better. It's a few more dollars, but worth it to me if it's a better clutch. Has anyone had experience comparing the two in actual use?

Thanks in advance for your answer.

Old Fart
 

spyder1968

New member
Messages
285
Reaction score
1
Location
New Bedford, MA
i have used both......although NOT on the same kart. imo, the hillard IS a bit better......but it's not a " nite and day" difference.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
If you require a new clutch get it. If a new clutch is not required, stick with the Max Torque 'ss' clutch.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i had a hillard on a kart with 6:1 ratio and i think 16" tires. it seemed like it had a rough engagement. but that clutch was rednecked- had a modified max torque drum to fit it

the max torque had a smoother engagement but definitely got hotter, and burnt out. the high gearing was probably the reason why

the hillard uses "C" looking springs, the max torque uses a coil spring all the way around the weights.

the max torque has (5 or 6?) shoes, and the hillard has 4.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
This is probably a strange question, but how is the spring tension rated on cent clutches? I don't see how those little weights can overcome that force of the spring, but somehow they do..
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
This is probably a strange question, but how is the spring tension rated on cent clutches? I don't see how those little weights can overcome that force of the spring, but somehow they do..

it does seem pretty tough but when you got it turning at 3600 rpm thats a lot of centrifugal force
 

Br@ndoM@n

Dude with a gokart, a MIG
Messages
88
Reaction score
4
Location
New Mexico (Not Dirty Poor Mexico, NO HABLA ESPANO
I just got a Hilliard Extreme Duty 10tooth 40/41 pitch 3/4" clutch for my GX160 and BIG difference from my old clutch. Although my old clutch was going bad before it self destructed anyway so really no comparison to between the two new.

The Hilliard unit seemed beefier than my old unit. So far im happy with it. untill I get a Tq converter. lol
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
And I assume clutches for 2 strokes (chainsaws, go peds, pocket bikes) use springs with probably twice the resistance since a typical weedeater easily hits 10,000 RPM if you run it on the lean side.
 
Status
Not open for further replies.
Top