Well, this is my first time converting a vertical engine to horizontal, so I decided to stop bumming off of TS's LB thread, and start my own. Before I even get into this, I just found today that our friends have a dead snowblower and dead weed wacker! They offered both to me. I couldn't say yes fast enough.
Anyways, onto this engine. It's a Briggs 190cc. Here's a quick photo timeline of today. I need to get a positive ID on this since I messed up the gaskets when splitting the case open. The carb wasn't in bad shape considering it had no air filter and the air box was blown out. It looks like it backfired and blew a hole in the air box? I was SO happy to see a straight, keyed shaft. It also have 2 half circle key slots in the opposite side. Once I dropped out the motor, which was only held on to the deck by 1 bolt (3 holes though), I nearly threw a party when I saw the PTO.
Anyways, onto this engine. It's a Briggs 190cc. Here's a quick photo timeline of today. I need to get a positive ID on this since I messed up the gaskets when splitting the case open. The carb wasn't in bad shape considering it had no air filter and the air box was blown out. It looks like it backfired and blew a hole in the air box? I was SO happy to see a straight, keyed shaft. It also have 2 half circle key slots in the opposite side. Once I dropped out the motor, which was only held on to the deck by 1 bolt (3 holes though), I nearly threw a party when I saw the PTO.
The whole insides of the engine were just black.