So I have a Honda GC160 engine from a pressure washer that I want to put on a Go Kart, But the crank shaft is 7/8" dia. The only clutch turning up is a V-Belt clutch by comet that has a 7/8" bore. But i cant seem to find a pulley to mount on a live axle. Any ideas?
Where do i find a pulley?
- Thread starter Daniel13
- Start date
- Status
scar
muahahahahahaha
- Messages
- 72
- Reaction score
- 0
ebay has a few clutches that run a chain that are 7/8 bore http://shop.ebay.com/?_from=R40&_trksid=m38&_nkw=7/8+clutch+go+cart&_sacat=See-All-Categories
Kenny_McCormic
Kartless....
Run a 3/4" jackshaft, put $30 clutch on jackshaft, engine drives jack 1:1 with cheap sprockets and a chain.
EagleTalons
Master JB Welder
What does it mean to run a jackshaft?
- Status