Torq Converter problems with unknown kart

Status
Not open for further replies.

Stanman

New member
Messages
3
Reaction score
0
I have a go kart of an unknown brand, hopefully someone can identify it for me.
The pics here not of my actual kart but are screen caps from the exact same kart on YouTube.
Can anyone tell me what kind of torque converter came on this type kart, the one in the picture, and what belt I would use?
Again this is NOT my cart in picture.
My problem is the clutch on my kart is a Comet async torque converter but as you can see from the pics the driven pulley is facing backwards from how it should on a comet async setup so this puts the slanted side on one side on the drive and the other on the driven. Results? it eats belts in a couple minutes.
If I get a comet sync or max-torque unit do I need an inboard or outboard?:worried2:
 

Attachments

  • cart2.jpg
    cart2.jpg
    59.2 KB · Views: 16
  • car3.jpg
    car3.jpg
    57.4 KB · Views: 17
  • cart4.jpg
    cart4.jpg
    62.2 KB · Views: 15

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
Its a carter kart, series 20 comet torque converter. Belt is either a 203583 or 203581 depending on the length, please refer to my other thread regarding torque converter maintenance under clutches section of the forum for the sizing chart.
 

Stanman

New member
Messages
3
Reaction score
0
Its a carter kart, series 20 comet torque converter. Belt is either a 203583 or 203581 depending on the length, please refer to my other thread regarding torque converter maintenance under clutches section of the forum for the sizing chart.

Thanks Blazkowiez,
Is carter the one that mixed asymmetric with symmetric units?
I am assuming that the comet series 20 you refer to is symmetric but what is confusing me is that my driven unit says comet 20 on it and and it has one straight and one slanted side.
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
Nobody "MIXED" the units, they might have used one on one design and one on another, but they don't use a series 30 driver and a series 20 driven, the 20 on driven is a cam measurement and not a reflection of the series. You notice the driven clutch in the picture is running inboard which is impossible for series 30.
 

Stanman

New member
Messages
3
Reaction score
0
I got it figured out and fixed. The large pulley, comet 30 series Asymmetrical was on backwards so the easiest way I could fix it was to move the motor over an inch to the right and turn the pulley around the way it should be.
The belt is perfect now.
 

Attachments

  • DSC00873.jpg
    DSC00873.jpg
    95.8 KB · Views: 12
  • DSC00876.jpg
    DSC00876.jpg
    124.6 KB · Views: 9
Status
Not open for further replies.
Top