TAV2 30-75 Torq-A-Verter question

Status
Not open for further replies.

hd_fatster

New member
Messages
5
Reaction score
0
I just bought a TAV2 30-75 Torq-A-Vertor clutch fairly cheap for $169 and received it last week. I just opened it up sunday and noticed a few parts missing based on the parts list diagram they supplied. It was missing four 5/16 lock washers, no big deal, can pick them up nearby anyway.

But it was also missing what was described as a 5/16 ID pilot washer that looks like it retains the outer portion of the drive pulley by the bolt that bolts into the end of the crankshaft. I emailed the sales staff of the distributor and he say that item is no longer shipped and needed with the kit. I'm not buying that. The bolt head isn't big enough alone to hold the outer portion of the pulley on. So my question is: Can anyone who has this clutch tell me what size this pilot washer should be so I can obtain one or fabricate it? I know the ID is 5/16, but also need to know what the OD and thickness is? I'm thinking OD needs to be about 1-1/4" or so, thickness unknown and not very important except thick enough to be strong enough and not too thick that it pushes the crankshaft bolt out too far that it interferes with the plastic outer cover.

Thanks,
Jim
 

augidog

New member
Messages
329
Reaction score
0
TAV2 & Torq-a-Verter are terms proprietary to Genuine Comet Products, did you buy genuine or a copy? and if you don't mind saying so, who is the supplier?

this might help you pick out a washer: http://www.mfgsupply.com/gomini/gom...v30/gominiclutchtorqtav2parts/200840a-w1.html

i bought a coaster-brake bicycle wheel once, and i chose the cheaper version, a "shimano" copy...the wheel arrived without the brake-arm or sprocket...and guess what i was told when i inquired? that $5 decision ultimately cost me a lot more than $5.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
I would just get a standard penny washer that is large enough to catch on the driver and hold it on. Say, 1" or larger outer diameter, maybe even 1 1/4" (assuming 3/4" drive)
I doubt thickness would make a lot of odds.
 

augidog

New member
Messages
329
Reaction score
0
r_chez_08, the washer has to resist the wedge-effect of the lead weights...so i'll say, imo, thickness does matter to an extent, but doubling-up a couple thinner washers would work too i think.
 

hd_fatster

New member
Messages
5
Reaction score
0
I bought it from GoPowerSports.com. I just assumed it was a genuine Comet, didn't realize there were knockoffs out there. If it is, hopefully it will work ok.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
r_chez_08, the washer has to resist the wedge-effect of the lead weights...so i'll say, imo, thickness does matter to an extent, but doubling-up a couple thinner washers would work too i think.

Sorry, what I meant was the thickness in terms of hitting the cover. Obviously the washer does not want to be too thin because it will bend. I would say maybe 1/16"
 
Status
Not open for further replies.
Top