Tav 2 series 30 pulley alignment problems

Status
Not open for further replies.

Cash_578

New member
Messages
5
Reaction score
0
I'm new first off so be patient. I recently built a buggy from scratch and when I installed the tav 2 to the predator 212 it ran ok for a bit but burned a belt. When I went to install a new belt, the tires are too big I know, I noticed that the drive pulley and the engine pulley did not line up by about 3/8" on the flat side. The spacer is installed on the engine shaft but it seems I need 3/8" more for it to line up with the drive pulley. What am I doing wrong? I'll post pics tomorrow. I just didn't know if there were other issues like this posted before.
 

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
Post the pics tomorrow,,, until then its just too hard to say anything, too many variables.
:welcome2:
 

Cash_578

New member
Messages
5
Reaction score
0
Here are the pics. Any guesses????
 

Attachments

  • 20151228_162812.jpg
    20151228_162812.jpg
    241.9 KB · Views: 12
  • 20151228_162750.jpg
    20151228_162750.jpg
    244.6 KB · Views: 17
  • 20151228_162759.jpg
    20151228_162759.jpg
    293.4 KB · Views: 9

Cash_578

New member
Messages
5
Reaction score
0
Here is the buggy 90% finished.
 

Attachments

  • FB_IMG_1451342800342.jpg
    FB_IMG_1451342800342.jpg
    38.3 KB · Views: 8

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
I am not sure... but it looks like you can space the engine pulley out to the end of the shaft at least. You can try it with just washers, see where that gets you. Someone else will chime in soon too.:thumbsup:
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
You can get an 8t type C 5/8" bore jackshaft sprocket to help put more torque to the tires.
 

Cash_578

New member
Messages
5
Reaction score
0
If I space it out too far the pulley that fits on the other side of the engine shaft won't fit on there. If anything I need to move the drive pulley in somehow. This is a basic setup for a predator engine.

---------- Post added at 08:55 PM ---------- Previous post was at 08:53 PM ----------

Thanks kartfab. I have found a 9t but haven't seen the 8t.
 
Status
Not open for further replies.
Top