Rebuilt Tecumseh OHH50 wont start

Status
Not open for further replies.

Hot Rod Go Kart

New member
Messages
4
Reaction score
0
I got a Tecumseh OHH50 that i recently rebuilt, rebuilt the carb, new fuel line and the timing is right. I sprayed some starting fluid in the carb and got it to fire but not turn over. I'm out of ideas why it wont run. Any help?
 

brendonv

New member
Messages
861
Reaction score
3
Location
Australia, Perth
Check spark. If thats good then put fuel down the spark plug hole, put plug back in and try start it. If it fired it means your carb is blocked. If it doesnt fire and u have spark your timing is off.
 

Hot Rod Go Kart

New member
Messages
4
Reaction score
0
OK. I have a blue spark. Whats the best thing to do if the carb is blocked? Could the governor not be set right? The timing dots on the crank and cam are lined right up. Its like its not getting fuel which would probably be like you said with a blocked carb.
 

Hot Rod Go Kart

New member
Messages
4
Reaction score
0
I let it soak in carb cleaner and I blew it out with the compressor and shot carb cleaner through it with the hose on the can... still nothing. I noticed when I worked on the carb the other day, the seat I think is missing on the jet. That might be my problem. Just doesnt seem like its getting gas through the carb though.
 

DirtTrackRacer_07

DeeR SlayeR
Messages
222
Reaction score
1
Location
tennessee
Is your needle letting enough fuel in the carb bowl?

Make sure you have good fuel flow into the carb

I have seen were the gas tank cap wasnt leting no air in the tank and cause it to not get enough fuel flow.

It creates a suction on the tank about like a vapor lock.
 
Status
Not open for further replies.
Top