Predator 420cc balance crankshaft

Status
Not open for further replies.
Messages
357
Reaction score
7
Location
Dallas, TX
Since I’m in the process of building a 420cc with a stage 2 kit and will be turning about 7K or so RPM I was to remove the counter balance shaft and get the crankshaft balanced so it doesn’t shake everything loose. All I’ve been able to find is stroker balanced crankshafts for sale, but not any OEM style crankshaft they are balanced.

Does anyone in the DFW area (Lewisville, TX is where I’m located) know of a shop where I could take the crankshaft to get it balanced and about how much I should expect to pay for it. If there is a place I can buy a crankshaft that is already balanced (non stroker) please let me know.

Thanks in advance.
—Daniel
 
Messages
357
Reaction score
7
Location
Dallas, TX
Just had a thought... if the balance shaft is fine to take the 7K or so RPM I have no problem leaving it in. Anyone have thoughts about just leaving it in there and hoping it doesn't granade itself when racing?

--Daniel
 

Joe-405

Enjoying New Projects
Messages
2,673
Reaction score
98
Location
U.S.A.
I just pulled it out of my 420cc when I built mine. I had some very minor vibration differences but nothing serious to cause harm. NR Racing will balance the assembly tho for about $150
 
Messages
357
Reaction score
7
Location
Dallas, TX
Yeah saw the vid C&C did and they just ditched the balance shaft. If it will not cause harm to run without the shaft it will just come out. I will contact NR racing just in case and see what they say but I guess I will try to run it first on my test bench without the balance shaft see what it does. Thanks.
 

Joe-405

Enjoying New Projects
Messages
2,673
Reaction score
98
Location
U.S.A.
The NR owner told me to try it first. I bought my cam and stuff from him. Which is why I didn’t have it done and also know that they do it.

It will slide out. BE CAREFUL with the bearing on the block !!! I cracked my block getting it out and had to have my buddy tig weld it back up. See pic for reference..........
 

Attachments

  • EB8A5396-4D40-49E7-9533-0354118C27FE.jpg
    EB8A5396-4D40-49E7-9533-0354118C27FE.jpg
    246.8 KB · Views: 18
Messages
357
Reaction score
7
Location
Dallas, TX
Yup, I will try it without it first see how it goes. What is the best way to get that bearing out? I saw in the C&C vid they welded a nut on the bearing and hammered it out. Rather not weld in there (I only have a flux core welder) but if needed I will give it a shot.

Thinking something like this may be a better tool to use.

https://www.amazon.com/PMD-Products...ocphy=9026832&hvtargid=pla-570590597993&psc=1

--Daniel
 
Status
Not open for further replies.
Top