Predator 212 Surging?

Status
Not open for further replies.

Predator2122

New member
Messages
3
Reaction score
0
Hello,

First, this isn't for a go kart. Just getting that out of the way. Although thanks to the go kart community, the popularity and familiarity of this motor is well known and i'd like to ask you for some help.

Reading in and out of all these forums and misc youtube videos, i decided to build a mud motor and use a predator 212 engine. 6.5 hp was okay, but considering the ease of upgrading this engine, i decided i would pick up a hop up kit.

http://www.ebay.com/itm/ws/eBayISAPI.dll?ViewItem&item=171669693098&rmvSB=true

Aside from installing the emulsion tube, jet, air filter and exhaust...The only other modification I've done was to pull back the throttle set screw. I did all of these things before i even put gas in the engine so i'm not sure what is specifically attributing to the surging. It seems anytime it's throttled above 50% it starts to surge. The only thing i could think of was that maybe its not getting enough gas and i need a bigger jet.

Any suggestions or thoughts are appreciated. Vid of surging below.

https://vimeo.com/149095997
 

thebroketeenager

New member
Messages
95
Reaction score
1
Location
Bakersfield California
Thats likely because the motor is not under a load..when not under a load the governor gets twitchy and causes your problem. my go kart does the same thing just spinning the wheels in the air. I would say its normal.
 
Last edited:

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
I agree totally. drop that in the water put it under load it should resolve your surging issue.

---------- Post added at 07:03 PM ---------- Previous post was at 06:58 PM ----------

Also you may want to disconnect the low oil switch. It will cause your engine to shut down unexpectedly for no apparent reason anytime the motor is unlevel, while bouncing or turning.
 
Status
Not open for further replies.
Top