Porting my 8hp Flathead

Status
Not open for further replies.

jamyers

Well-known member
Messages
1,444
Reaction score
49
Location
Buffalo Gap, TX
Briggs 8hp Horizontal Flathead w/ cast-iron cylinder liner. Not a racing engine, just one on my kid's kart. I've done my own "street/strip porting on my Buick 455 and Ford 200, so it just seemed the thing to do to this engine once I had it apart anyways.

I used my air-powered die grinder with a 3/8" carbide round-nose burr for the rough cutting, with sanding rolls for cleanup. The carbide cuts quickly, so if you use one be SURE to brace your work and self or it can go through aluminum like you wouldn't believe. I've got a lot more polishing and cleanup work to do, but here's the progress so far.

The Chamber: I've cut the "eyebrows" (I think it oughta be called the "mustache", but I'm the new guy so...) down nearly to the level of the top of the valve seats. I didn't cut it down completely flat, but left a kind of a "hump" between the valve and the cylinder. My thinking is that a curve is better than a corner. I chamfered the very top edge of the cylinder liner, being VERY careful to stay well above the highest point the rings can get - which was obvious after using a ridge reamer. On the intake side (which curves inward), I went out to the head gasket, but on the exhaust side just eyeballed it - didn't want to remove too much material, and from what I gather the exhaust doesn't need near the help that the intake does.


The Ports: The only other place I've seen this much casting flash, bumps, and obstructions in an engine is inside my Ford inline 200 with the integral log intake 'manifold'. Sigh...

I didn't try to enlarge anything any more than necessary. My main goal was to just remove the casting flash, goofy seam irregularities, and smooth out any huge bumps in the port walls. The only place I tried to get technical was on the short side radius (the "inside of the corner" where the flow goes from horizontal to vertical to get past the valve. I laid that radius back, giving as smooth a transition as I could.

On this engine, the valve seat ID's are noticeably smaller than the block, leaving quite a ledge under the valve. I VERY carefully undercut the intake seat a little bit, just to take that edge off the underside. If I knew what I was doing with epoxy (and was trying to go for broke on this project), I'd add some to make it a smoother passage - and in the outside/bottom corners of the bowl area as well.


Here's where I'd add epoxy or something, from down in those corners to up under the valve seat. Make it a nice, rounded bowl instead of a 2-cornered mess.


Exhaust Port exit, looking inside at the bowl. The valveguide was sticking up 1/2", there was so much casting mess in there that it's a wonder anything ever got out of the engine. I also removed the threads, making it a true 1" exit port (the stock muffler has a .8" inlet, no wonder they're so restrictive). I'll fab up an exhaust pipe/header later on, and do a good deal more polishing in there as well.


Intake Port: The carb / 'manifold' bolts straight to the block, then the intake port makes a quarter-left-turn inside the block to get to the bowl. I cleaned this up a good deal as well,, and gasket-matched the opening. I'll do some more cleanup, but not going to polish this port. Now that I think of it, I might cut a wedge out of the intake to get the carb aimed same as the port - have to look at that...


Comments, Suggestions? (cross-posted over at www.karting.4cycle.com to get the racer's view as well)
 
Status
Not open for further replies.
Top