piston tough to crank

Status
Not open for further replies.

tundrabeagle3

New member
Messages
448
Reaction score
2
Location
Ca
im rebuilding a old 2 hp briggs. i took out the piston cleaned put it back in and bolted it to the crank.when i tried to crank it by hand with the flywheel i noticed it i could not crank it. i can crank it with socket but even that is hard. i put oil in the bore before i put the piston in i dont know what the problem is.
 

Jcotz

...wasn't there
Messages
374
Reaction score
1
Location
NY
Look at your manual and look at the torquing specifications. You must torque everything correctly with a torque wrench.
 

tundrabeagle3

New member
Messages
448
Reaction score
2
Location
Ca
i just loosened the bolts and it did the trick. i just finished cleaning all the parts , and tried to start it and it wont start. i never had this engine running i got it with my minibike in a package. im going to try to sell it do u guys think $35 is a fair price?
 

devino246

Official DIYGK Chem Nerd
Messages
3,856
Reaction score
17
Location
Lynchburg, VA
Tightening an end cap correctly involves torquing each bolt incrementally. Torque one bolt, move to the next. Move up 5 in.lbs. and repeat. Do this until you reach the torque spec.
 

tundrabeagle3

New member
Messages
448
Reaction score
2
Location
Ca
i dont have a torque wrench but i was able to crank the flywheel with my hand.and i couldnt fit a socket on it because the oil dipper was in the way. i decided to sell it because i dont want it sitting in my garage.
 
Status
Not open for further replies.
Top