New Clutch Flew Apart

Status
Not open for further replies.

fricard

New member
Messages
5
Reaction score
0
Location
Shoreline, WA
First test-run last night:
This is a new gokart (Azusa Road Rocket) new build, new engine, new everything.
Started it up, engine ran nice. Let it warm up a bit, everything seemed to be okay.
Drove it a short distance and at about 20 feet, suddenly, the four clutch weights & springs flew out of the clutch housing.
The weights look okay, like they could go back in, but I 'think' the springs look stretched maybe.
What the heck could we have done wrong?

This may be a good opportunity to go ahead and buy that torque converter that I was planning on for our first upgrade; rather than clutch parts.

--FR
 

fricard

New member
Messages
5
Reaction score
0
Location
Shoreline, WA
It's the stock 3/4 inch bore centrifugal clutch that gokartsusa sells for the Road Rocket kit; 12-tooth for #35 chain.
--FR

Sent from my Nexus 5X using Tapatalk

---------- Post added at 08:47 AM ---------- Previous post was at 08:38 AM ----------

we need a picture !
something was not installed right.
I'll see about taking some pics tonight.
Thanks.
--FR

Sent from my Nexus 5X using Tapatalk
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
What was the clutch and how was it mounted?...
Is it a Hillard by any chance.. With the C shaped springs..
They have a backing plate that needs to be used in the correct orientation, or a detention may occure.
 

fricard

New member
Messages
5
Reaction score
0
Location
Shoreline, WA
Yes, on the 'C'-shaped spring clips.
Not sure of the actual brand. I suspect it's a cheap knockoff.
I'll check on the backing plate tonight; I honestly don't remember.
--FR

Sent from my Nexus 5X using Tapatalk
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Here's from the instructions I saved along time ago...
If this is how it is installed it's probably why it flew apart...
 

Attachments

  • image.jpg
    image.jpg
    270.3 KB · Views: 6

fricard

New member
Messages
5
Reaction score
0
Location
Shoreline, WA
No, fortunately it was not mounted with the weights exposed to the outside. The housing was turned around (from the above photo) the correct direction, however, the weights were able to come loose.

I'm thinking the backing retainer is missing and/or the housing is not covering the weights fully. I did come across a video where the mechanic explains that some housings to do not slide onto the shaft to far enough, so that might be in play here.
A buddy of mine did just tell me that his weights also ejected on his first run too.
In any event, I think the springs have been deformed so as to be unusable.
 

Attachments

  • IMG_20170713_061522.jpg
    IMG_20170713_061522.jpg
    328 KB · Views: 2
  • IMG_20170713_061654.jpg
    IMG_20170713_061654.jpg
    192.7 KB · Views: 4

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Post a full pic of all the pieces of the clutch...
It shouldn't have that amount of stick out from the shaft...
 

fricard

New member
Messages
5
Reaction score
0
Location
Shoreline, WA
Yeah, I haven't taken it off yet, but am thinking it was possibly an installation error on the part of my teenagers (and mine for not inspecting closer).
 
Status
Not open for further replies.
Top