Lawn Mower Engine?

Status
Not open for further replies.

outdooz

New member
Messages
99
Reaction score
0
I have a lawn mower engine with a vertical shaft. I know it going to be hard, but whats the best way to get it to power the rear axle? Without a transaxle.
 

devino246

Official DIYGK Chem Nerd
Messages
3,856
Reaction score
17
Location
Lynchburg, VA
I have a lawn mower engine with a vertical shaft. I know it going to be hard, but whats the best way to get it to power the rear axle? Without a transaxle.

You have 2 options:

-Convert to horizontal(cheapest option)
-Buy a right angle gearbox(expensive)
 

freakboy

the names 'mater
Messages
3,961
Reaction score
2
Location
hick town
right angle gear box. basicaly 2 shafts and 2 gears inside they make them in different ratios.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
how is buying an RAGB cheapest? what do you need to convert to horizontal, some scrap metal, and a few tubes and pipes.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
You're in the neighbourhood- A few bits of info required- How large are the shafts, how big and heavy is the unit, what is the max torque or HP ratings, and what is the ratio.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
after looking at what was on the products website, i can't be sure exactly which model he is selling, but i can say from what i can tell unless your running a 2.5hp engine at the most it can't handle the power.

what about bending a v-belt? i have seen pics of it done, i had a few ideas a while ago, but i can't remember them right now, i will post any that i remember.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i vote bending the belt.

converting the vertical to horizontal can be risky, who knows if your slinger will work right, who knows if it will even run without wicked modification.

if you decide to use a 90* gearbox, either find something perfect for cheap, (and strong) or just make your own from some bevel gears, pillow blocks, and thick sheet metal.
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
Try to scrap a RAGB from a snowblower. There should be at least one in EVERY snowblower, maybe two. They have reductions so the clutch must be prior and gearing worked between the RAGB out and axle.
 

jrmints1415

New member
Messages
570
Reaction score
4
Location
Naperville Illinois
i agree with blue. Bending the belt would be the best option in my opinion and i have been thinking about this idea for a while and have found a possible solution of the wear on the belt. You have a vertical shaft engine that has a pulley on it already. if you connect the belt to a "jack shaft" at a 45 degree angle the wear of the belt will be much less. Then you simply have another belt bending the other 45 degrees so that the wear is cut in half. You will need: 2 belts, 4 pulleys, including your drive axle and PTO shaft of your engine, a small piece of round tubing (used as jack shaft and also so you can weld on your pulleys, and a way to mount it at a 45 degree angle. i have never tried it but theoretically it would work right? i dont know but i would try it to see if it works haha. if you do not understand it i will draw a diagram if needed
 
Status
Not open for further replies.
Top