King Cobra Problems

[Jdbuggy]

I bought a project kart and it appears to be a king cobra based on the frame and vin. It needs some rewiring, but the wiring diagram for the cobra doesn't match my kart. For example, the diagram shows a 3 wire ignition, but this is a 5 wire with relay. The diagram shows a speedometer, but this has a tach. Was there multiple king cobras made?

 

[Budget GoKart]

There probably was so I would suggest looking at other manuals

 

[Jdbuggy]

I've looked at every manual I can find and search the net high and low with no luck. My hope is that some will recognize it and be able to shed some light on it. I know carter bros made thes then BMS and yinxiang. It looks lime a bms, doesn't match that manual. I even purchased the full manual hoping it had multiple schematics that didn't get uploaded. No luck.

 

[Joe-405]

Picture of the dash ?

It looks like Maxon made it also. By my searching.

 

[Jdbuggy]

Here's a pic of the dash.

 

[Joe-405]

Go look at the Hammerhead gts150

It has almost the same dash with the tach in the same spot.
It also has the 5 wire ignition switch.

 

[Jdbuggy]

I can't seem to find a 5 wire gts. They show 3 wire in the manuals.

 

[Joe-405]

I can't seem to find a 5 wire gts. They show 3 wire in the manuals.

Hammerhead part # 20-0301-00

 

[Jdbuggy]

That's actually the key switch on my kart, but why does every schematic the key goes to show it as a 3 wire? Am I reading it wrong lol?

 

[Jdbuggy]

Anyone?

 

[Budget GoKart]

Ah sorry I will post a link in a min I will be making an update later but this is basic wiring
http://www.diygokarts.com/vb/showthread.php?t=43367