Is this a reliable ENGINE?

Status
Not open for further replies.

island

Guam U.S.A
Messages
75
Reaction score
0
Location
Guam U.S.A
Happy Thanksgiving every1, Does any1 know what engine is this? Is it a good engine, and how can i find out how many horses is it or a link for info on it? Thanks


[/IMG]
 

jrmints1415

New member
Messages
570
Reaction score
4
Location
Naperville Illinois
looks to me to be a 6.5 hp motor from a generator. If you are going to put that on a cart you will need a new crankshaft. also you can check and see if theres good compresion and spark to tell if it is decent shape or not.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I'm going to guess that it's a chinese clone of a Honda GX. Possibly smaller than 6.5 hp. For what it's probably going to cost to pur a new crank in it, you might want to consider another engine. It looks kind of old and beaten, and isn't worth much. Also, if it is a clone as I suspect, you're going to be hard=pressed to find any info on it. you might get lucky and find a casting mark that indicates displacement, but I wouldn't count on it.
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
i would assume that it being upside down in a generator aplication would heat up the metal it touches underneath, unless the engine sat above the floor pan,also from judging off the recoil looks like an 11/13hp generator motor, only 11/13 hp's have that big a recoil it seems
 

jrmints1415

New member
Messages
570
Reaction score
4
Location
Naperville Illinois
however if it were in a generator as i assume it was it would need to be pretty compact and this setup is Way more compact then if it was facing up, but i guess it could be upside down.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i think its an OLD gx200 or copy.

bad things: crankshaft needs to be changed or machined, and throttle is set up for fixed speed.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Doesnt look like a genuine gx. Carb and filler cap are a few of the differences. May be old design. Does it start and how big is that shaft below the block? Look for markings, for displacement or a code.
 
Status
Not open for further replies.
Top