Honda performance parts?

Status
Not open for further replies.

stargazer7467

New member
Messages
34
Reaction score
0
well i was looking to get at least a billet rod, im looking into removing the governer. Yeah the "head" is not removeable.

The timing belt is a cogged belt like any other timing belt is, produced by Gates. Nitrile and EPDM belts have a great tolerance to oil and brake fluid, so no worries there.

I swore i came across a place that sold cams for them but i might be confusing them with the GX motors.

I remember briefly seeing the Subaru engine at harbor freight, other than that ive never seen them again. Interesting design, and fuel injection is sweet!

About the only thing i hate about this GC160 is the "shishkabob" carb/airbox/choke plate/spacer setup. Two long bolts hold the entire side of the engine on.
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
Yup, took my gov out. Might as well as it's all apart anyway.
As far as carb goes...I am going to try out one of my Tillotsons.
I am going to push this engine to beyond its limits.
I'd really like to see how much it can take.
I haven't thrown a rod in a few years.
"shishkabob" carb/airbox/choke plate/spacer setup.
It is a gasket makers nightmare.
 
Status
Not open for further replies.
Top