Honda 11hp starter and kill switch

Status
Not open for further replies.

NotSoMasterMind

New member
Messages
112
Reaction score
1
Location
South lyon michigan
So i got a 11hp honda engine (from a powerwasher since we have 4 laying around) and can i just unscrew and take off the kill switch and put it about 3 feet away? Or do i need to wire it or can i just move it. Also since if is pull start, is there anyway i can put a starter to it, since i have an extra battery and such? To add on i have a taotao ata-125g motor with a starter on it, can i use that? Pics will come soon
Life is not about what you do, its about what you can do. You only have one shot, it may only come once in a life time
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
So i got a 11hp honda engine (from a powerwasher since we have 4 laying around) and can i just unscrew and take off the kill switch and put it about 3 feet away? Or do i need to wire it or can i just move it.

Well, of course the wires need to be connected, otherwise nothing would happen...

The simplest way to connect a remote killswitch is to disconnect the low oil sensor (the yellow wire coming out of the engine block) & wire a switch across it...

Also since if is pull start, is there anyway i can put a starter to it, since i have an extra battery and such? To add on i have a taotao ata-125g motor with a starter on it, can i use that? Pics will come soon

Unfortunately, it's not as simple as "bolt a starter motor on it", you need to change the flywheel for one with a ring gear, add charging coils & a bit of wiring...

Fortunately, there's complete kits for that
 
Status
Not open for further replies.
Top