Hi from Missouri

Status
Not open for further replies.
jaroddog

jaroddog

New member
Messages
13
Reaction score
0
Location
Northwest Missouri
Hey guys. Just picked up a welder and will be practicing with it soon so I get used to a MIG. I've always used stick welder in the past. I thought a go kart would make a nice eventual project once I'm comfortable again with my welding skills. I look forward to meeting everybody and hope I'll be able to contribute some knowledge: my engine experience is based around chainsaws. I rebuild them and make knives for a living. Hopefully I'll be able to absorb some of your experience and put to good use down the road. If you ever have a chainsaw question or want knife info, lemme know. I'm the owner of Big Creek Blades. Peace and axle grease. :thumbsup:
 
OzFab

OzFab

Well-known member
Messages
15,615
Reaction score
74
Location
Warwick Qld, Australia
:welcome2:

Some early go karts used chainsaw engines (google "McCulloch go kart"); so, how are you with small 4 stroke engines?

I found MIG is much easier than stick welding, you have more control so it's much easier to master; a bit of practice & you'll see what I mean ;)
 
Poboy kartman

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
72
Location
White Settlement Texas
Welcome to the forum! ... Hmmmmm ....."Show me State" eh???

Well this ought to be called the "Show me Forum"......we have a saying...."without pics...it didn't happen! "

So. ...just 2 things. ...Please fill out your profile so we will know where you are from in future posts. .....and post up plenty of pics. ......

I invented a knife. ...'The Poboy Knife"......not as famous as a "Bowie" knife.....but easier to make. .... (duct tape and a lawnmower blade)......I don't want to say anymore or I might give it away......:lolgoku:
 
Status
Not open for further replies.
Top