Help!!!!!!!!

Status
Not open for further replies.

8urn'7

New member
Messages
80
Reaction score
0
ok so heres the pictures of the engine without the case. does it look good?
 

Attachments

  • 2011-04-21 07.09.26.jpg
    2011-04-21 07.09.26.jpg
    83.2 KB · Views: 11
  • 2011-04-21 07.09.36.jpg
    2011-04-21 07.09.36.jpg
    55 KB · Views: 7

8urn'7

New member
Messages
80
Reaction score
0
immediate help!!

this motor hasnt ran in a while and when i try to start it. it makes a popping noise and some type of smoke or vapor comes out the carburetor. what should i do???
 

jeremybentham

New member
Messages
347
Reaction score
0
Location
Dutch Country
Is this the third thread you have started for this problem?
http://diygokarts.com/vb/showthread.php?t=11063&page=2
http://diygokarts.com/vb/showthread.php?t=11065
You can't yell at us and then expect us to help. Plain and simple.
As stated in your other thread, lightly sand the rust off of the plate on the flywheel. There is a photo of this in another thread you started. Loosen the bolts holding the coil. Place a standard business card in the gap between the plate and the coil. Re-tighten coil bolts. Remove card. This may fix your weak spark situation. If not, your problem may lie elsewhere.
This entire forum is full of info. Take the time and look around on your own as there are MANY threads dealing with starting issues, motors that have sat for awhile, et cetera. Scour them and you will learn. You can't just start multiple threads about the same problem, with very little detail and expect us to help you. We need as many details as you can possibly provide if you expect a satisfactory solution.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
um..... just a tad of rust..... sand off the magnets on the flywheel and the contact surface on the coil, regap, and try it. you may need a new coil.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Threads merged.
Please bear a few things in mind here-
One, that patience is a virtue. I know you're frustrated with your engine, but free 24-7 online tech support is pushing reality a bit.
Two, some folks may not be real keen about chasing down multiple threads by the same poster asking the same questions. It's a real pain in the rearend for those actually trying to help you. Please use some judgement about this.
Three, things don't often end up on silver platters. If you need help with something, nobody's going to wave a magic wand, and you're going to run outside and *poof!*- Your engine starts, has 500HP, and 4wd. The nature of the troubleshooting process is to ask the right questions, answer them, and base the next step on those answers. What that means to you, is that these people trying to help you need YOU to go put forth the effort to examine what they have pointed out already. Personally, there is not much that infuriates me more than putting forth an inordinate amount of time into trying to help someone, only to find that the party needing help couldn't be bothered putting any effort into being helped. I've said this before, and I'll say it again, "If you expect me to help you, I expect you to help me help you".

So be patient, do some homework, help us help you- and break out your tools...
Thank you.
 
Status
Not open for further replies.
Top