Help needed with ARC rod

Status
Not open for further replies.
N

NapO

New member
Messages
136
Reaction score
0
Location
Canada
I'm sure this may be a common porblem but when i went to un torque one of the bolts on my arc it just won't come out and it's starting to strip!! i got one out succesfully and get can't get this one out. i don't want strip anymore.... anyone got any suggestions. also how the heck do i get split reatiners off? there almost impossible to get off. need major help lmao...
:mad2::huh:
 
N

NapO

New member
Messages
136
Reaction score
0
Location
Canada
nevermind got the split reatiners off lol. quick question could i just start to run 26lb springs with the new cam or do i have to work them in with stock springs? what difference will it make?
 
1992suburban

1992suburban

I wanna go FAST!!
Messages
1,061
Reaction score
1
Location
Sanford, NC
what cam is it hard face welded???? if its hard stick them in.. be ready to spin the little motor to the moon so.... LET OFF THE GAS sooner!!
 
1992suburban

1992suburban

I wanna go FAST!!
Messages
1,061
Reaction score
1
Location
Sanford, NC


your springs look like these??
 
H

honda02

New member
Messages
78
Reaction score
0
Chances are he hasnt broken one yet, so keep ridin em. Do you have a 12 point socket for the thing like the instructions say?
 
newrider3

newrider3

New member
Messages
1,674
Reaction score
5
Location
Colorado
I believe part of your problem with the rod bolts is that you completely removed one before touching the other. You should loosen them both a bit at a time. Basically what you did is transfer all the load that was held by both bolts to only one bolt.
 
motor_head

motor_head

expert garbage picker
Messages
479
Reaction score
1
Location
sutherland IA
spit retainers are hell in a flatty, eatiest to set the motor upside down and put it together with a needle nose
 
Status
Not open for further replies.
Top