exhaust valve sticking open

Status
Not open for further replies.

portedmetal

New member
Messages
50
Reaction score
0
Location
Outside of Lafayette, LA
I just upgraded my valvetrain with new pushrods, a pushrod guide plate, and a .265 lift cam. It recommends 18lb springs which is what I have. My problem is that the exhaust pushrod keeps getting stuck in the open position. I believe it may be because of the increased lift from the new cam. Would this be a reason? Also would the 18lb springs not be sufficent enough to close the valve and would 26lb springs be a solution?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
You'd better double check the valve and rod for straightness. Check for ridges and burrs, too.

EDIT- Come to think of it, your thread title says the valve sticks. Your post header says it's the rod. Which part is actually sticking?
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
Make sure vale stems are not coked. Would appear as a brown stain.
This brown stain could represent an oversize condition causing valve to stick when pushed to something beyond its original designed limit.
Same thing with guides. Must be super clean.
 

portedmetal

New member
Messages
50
Reaction score
0
Location
Outside of Lafayette, LA
Sry for the confusion. It's the rod that's causing the problem. It's a brand new chrome moly rod. It looks like the rod is being pushed to far out the lifter chamber and getting caught on some sort of ridge causing it to stay raised. When i spin the motor by hand it works fine for a couple of strokes, then it gets caught.
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
Can you supply a pic of this ridge and associated parts?
Is it a purposely placed (manufactured) ridge or the result of previous wear?
I don't even know model of engine you are working on.
 

portedmetal

New member
Messages
50
Reaction score
0
Location
Outside of Lafayette, LA
I can get a pic but it won't be till the weekend. The motor is/was a 6.5 gx200. I believe the "ridge" is from factory. With stock cam/rods/and guide plate it would run fine. I got the new cam to increase rpm and figured the chrome moly rods would be a good investment in the long run.

I was also thinking about the new guide plate I have. Is it really necessary to have the thinner, Billet guide plate with these rods like is recommended, or would the stock plate be fine? I believe the stock plate has a smaller channel for the rods limiting side to side movement. But I'm not sure that's y I ask these questions to the experts like u guys.
 
Status
Not open for further replies.
Top