Cracked Crankcase Cover?

Status
Not open for further replies.

CriticalMass

New member
Messages
239
Reaction score
1
Location
East Bay CA
Sorry for the big pic, but is this crank case cracked or are these casting marks? I think it's cracked. And that sucks.

 

Wim

Jazz Maverick
Messages
87
Reaction score
0
Location
Oz
Could just be surface, they dont seem to continue up into the machined gasket surface.
 

CriticalMass

New member
Messages
239
Reaction score
1
Location
East Bay CA
Portions of these marks are raised, some seem recessed. I am sorry Russ I dint have a pic from the inside. I'll get one tomorrow. I was bored waiting for parts to come in so I decided to take a wire brush and steel wool to it. Now I'm inside, colder then a witches tit here.

The reason I thought or think it's cracked is it's worse at the bottom. Small hairline marks that look like shattered safety glass.
 
Last edited:

Bluethunder3320

New member
Messages
5,677
Reaction score
39
when i took the crankcase off a tecumseh H60 the inside looked like that. except a lot worse. when i washed all the crap and sludge off it it actually looked less cracked.

definitely some sort of coating, i doubt the aluminum does that.
 

CriticalMass

New member
Messages
239
Reaction score
1
Location
East Bay CA
No oil, and it doesnt appear to be cracked. I sanded it down with 80 grit and hit it with 220 to smooth it out. The marks must be casting marks. Just seemed odd how the casting marks were arranged, made it look cracked from stress.

All is well in the world, thanks for the input everyone.
 
Status
Not open for further replies.
Top