Couple B&S 5hp I have.

Status
Not open for further replies.

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
Couple B&S 5hp I have. Help?

So I have 4 B&S 5hp motors. At the moment, none of them are in running condition... I could have one running, but I dont care bout that one right now...

But the other 3 three Im a little more concerned with...
All 3 are seized up. I have one apart right now, it might just be a bearing, its going to get a mostly complete rebuild.
Any tips on what all I can do for this one? I want it mostly stock, nothing drastic.
I have it almost all apart right now.

The other two are both seized up, and have been sitting outside... for a long time... These two have a funky cover plate(whatever it is called)
This one is dark, sorry bout that
This one sticks out more.
Whats in there? Or is it because the motors are old?

I would like to rebuild those aswell, but make them have more oomf. At a later time...

Now for questions...
Im having a crap of a time trying to get the flywheel off one. Ill try to get a picture if needed.
Where can I get a complete gasket set?

Im sure there will be more...

Thanks!
:auto:
 
Last edited:

firekiller52

Flat Head Kinda Guy
Messages
58
Reaction score
0
Location
nj
the wider one appears to be either an internal clutch system, or a gear reduction. either way its a great setup, as for the flywheel, get some sort of a puller on it, tighten it up till its fairly tight(dont mess up the crankshaft!!!!) and if it hasnt broken free yet, the bolt on the puller just needs a couple healthy love taps from a bigger hammer and it should come off no problem
as for gaskets, NAPA,Advanced auto,Autozone all should have them, napa for shore can get them(thats who i use, but i also have a stock of small engine stuff from the 50 to like the early 90s from my dads old buisness)
o and pb blaster or ATF is your best friend when it comes to freeing up stuff,
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
Alrighty...

After looking the blue/green on over closer, I dont think it is a 5hp, it is a bit bigger... Anyway to tell what it is? Here are the codes on it.

As for the flywheel... it still has part of the pull start on it, I cant seem to figure out how to get it off. I do not see any bolts or anything... Ill try to get a picture soon.

Yes PB does help, got the piston loose on the one Im workin on now.

Thanks.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
14 = cubic inch, or 230ish cc
2 = design series
3 = horizontal
0 = Plain Bearing/DU Non-Flange Mount
2 = rewind starter.
6hp
Hope that helps :)
Rob
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
Yes, thanks!
I was kinda hoping for 8 or 9hp :p
How much hp could I get out of it with simple work?


Anyways, cant get pictures right now... internet at my house bit the dust..

Thanks.

Never mind. I figured it out, now I just need to get it off...
 
Status
Not open for further replies.
Top