Comet 20 / HF 6.5 blue clone

Status
Not open for further replies.

mikemerrill50

New member
Messages
2
Reaction score
0
Hey, new to the forum. I've been reading a ton on here, but I have one noob questions I can't seem to figure out...

I got a 5hp manco dingo 285 with a comet 30 torque converter. I got the 6.5 hf greyhound blue clone, and I can't seem to get the converter to mount! The TC has the plate that connects both pulleys, and the carb on the HF motor gets in the way to the point that I cannot mount the plate with the driven pulley / sprocket to the rear of the motor. A picture of the TC, which I know you are all familiar with: http://imgusr.tradekey.com/p-4574467-20110820015736/comet-torque-converter-30-series.jpg

It seems the only way to do this is to mount the TC backwards, so that the driven pulley is right behind the seat, which would mean I'd need to mount the engine about 8" further back. Is this a well-known problem, or am I an idiot?

Also, my kart does not have a mount in the rear for a free-floating driven pulley / sprocket as I see on some karts.

Thanks in advance,
Mike
 
Status
Not open for further replies.
Top