Finally getting around to starting build and just checking some measurements from a donor engine. Can't find any online for some reason.
How do these look. they are checked in 4 places 90 degrees apart.
Any comments would be appreciated. This is going on in an industrial plus block.
How do these look. they are checked in 4 places 90 degrees apart.
Any comments would be appreciated. This is going on in an industrial plus block.
Attachments
-
20220904_135619.jpg1.5 MB · Views: 11
-
20220904_135611.jpg1.4 MB · Views: 11
-
20220904_135603.jpg235 KB · Views: 11
-
20220904_135545.jpg1.4 MB · Views: 11
-
20220904_135538.jpg1.4 MB · Views: 11
-
20220904_135511.jpg1.5 MB · Views: 12
-
20220904_134825.jpg3.3 MB · Views: 13
-
20220904_134811.jpg2.8 MB · Views: 13
-
20220904_134757.jpg2.8 MB · Views: 11
-
20220904_134730.jpg1.5 MB · Views: 11