pfcperry18
New member
- Messages
- 2
- Reaction score
- 0
Hi guys. I just picked up a homemade kart with a 3hp Briggs on it. It seems to run kinda slow-ish and I think by removing the governor, I might be able to get the speed up a bit. What RPM's should I start to worry about grenading the engine around? Any other ways to up the power a bit? I'll post specs on the engine below.
No idea on gear ratios, but I might buy a lower gear set soon since I think the clutch is getting worn out. I want to drive it off-road (just in the dirt around my home) but if I stop in the dirt, it BARELY has enough power to get moving again.
I weigh about 230 and the kart weighs about 70-80, I think. Maybe 3HP is a little to low for me and the kart?
Briggs 3HP
Model Number 80212
Centrifugal Clutch
No idea on gear ratios, but I might buy a lower gear set soon since I think the clutch is getting worn out. I want to drive it off-road (just in the dirt around my home) but if I stop in the dirt, it BARELY has enough power to get moving again.
I weigh about 230 and the kart weighs about 70-80, I think. Maybe 3HP is a little to low for me and the kart?
Briggs 3HP
Model Number 80212
Centrifugal Clutch