Any Ideas?

Status
Not open for further replies.

jrmints1415

New member
Messages
570
Reaction score
4
Location
Naperville Illinois
I am removing the governor and cant get the ring that holds the gear on off. Does anyone know how to remove it? I already tried a screwdriver but i cant get leverage.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
you need to take the flywheel off, and gently hammer the peg out from the back side (it goes through the block)

be careful sometimes they go shooting out.

then take the gear off and replace the peg.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
by the way...... are you planning on a billet rod or flywheel?

for $60 the arc rod, $100 the flywheel, its extra insurance. i know how weak and cheap these stock parts are, they arent made for the RPM. IMO, if you have the money, or you can save up, they are worth every penny.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I am removing the governor and cant get the ring that holds the gear on off. Does anyone know how to remove it? I already tried a screwdriver but i cant get leverage.

I had the best results working two flat screwdrivers into the ring's gap, then twisting them away from each other to spread the ring. Either way, be gentle. If this engine is like all the other GX's and clones, I have been cautioned that the casting may be a bit thin and prone to breakage in that area.

I have no idea what this driving the peg thing out is about...
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
the peg is just held into the block because it is a tight fit in the casting. under the flywheel it comes out the other side.

the easiest way is to just tap it out, take the gear off, then tap it back in.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I can't verify the post-driving-out thing either. On my engine, anyway, I'm pretty sure the post was just part of the casting, an attempting to drive it out would just kill it.

Be patient, pry away at it slowly. It'll come. I took my time, I think it took about 20 mins of very gentle nudging.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Cool. That's a new one on me. I don't know if that's true for ALL clones/GX's. Be dead sure before beating the snot out of something that isn't meant to come off...
 

devino246

Official DIYGK Chem Nerd
Messages
3,856
Reaction score
17
Location
Lynchburg, VA
I didnt touch the flywheel when I removed mine. I ended up destroying the plastic gear in the process, though.
 
Status
Not open for further replies.
Top