Airbubbles in Fuel lines

Status
Not open for further replies.

HellSpawn

New member
Messages
476
Reaction score
2
Location
Wadena, Minnesota
Alright, So I've been doing some much needed work on my 87 Arctic Cat Pantera, Got a new fuel pump in hopes that it would fix how the thing ran, (it would bog out like it was lean.. which is was.)

Got the new pump all hooked up, thing idles beautifully, but still bogs under a load, However now it seems rich..

But, I also have airbubbles in my fuel lines, making me wonder how its running rich without getting alot of fuel..

Any ideas?
 

HellSpawn

New member
Messages
476
Reaction score
2
Location
Wadena, Minnesota
All of the fuel line is brand new, pump is new so the diaphragm is good.

Only item I haven't replaced is the vacuum line itself, which I just looked at and it does seem dry rotted.
 

HellSpawn

New member
Messages
476
Reaction score
2
Location
Wadena, Minnesota
They are constantly forming after the pump, I can't tell if there are any before the pump as I'm using a chunk of black line for that section.
 

HellSpawn

New member
Messages
476
Reaction score
2
Location
Wadena, Minnesota
I suppose I'll disassemble the pump and check to see if I just got a bad pump then.

I should probably check the pickup line aswell, never replaced that, Almost wonder if the weight/filter fell off.
 

HellSpawn

New member
Messages
476
Reaction score
2
Location
Wadena, Minnesota
If it where me I would always use a clear line like Tygon yellow or something, Really good in the cold. Only braided black line that should be used is the vac line. To be rich it doesnt need fuel pressure or alot of fuel flow, Just needs a full bowl and too big of a jet.

I know that, but I'd like to solve one issue at at time, and currently, the thing does eventually clear out and scream at 8-9k, however, it'll lean out from the pump not being able to keep up.
 

HellSpawn

New member
Messages
476
Reaction score
2
Location
Wadena, Minnesota
Alright, so I discovered the fitting that goes into the tank for the pickup line was cracked and pretty much rotten, 90% chance that was my air-leak. Need to make a fitting or pick one up from somewhere, as it requires a fuel nipple on both ends, (one for the pickup line inside the tank, and one for the outside to the pump.)

The inner pickup line is in great shape, very flexible, and the filter/weight looked good.
 
Status
Not open for further replies.
Top