1975 Briggs and Stratton 5hp engine

Status
Not open for further replies.

Gokartguy04

Pickin junk is my thing
Messages
29
Reaction score
0
Location
Colorado
Hello guys,
I am kinda new to this fourm stuff but I need someone to answer this question if any one can. I have a 1975. Briggs and Stratton horizontal shaft 5hp engine and the piston rings are bad. So can I just put new rings on the old piston or do I have to buy a hole new piston.
 

Br@ndoM@n

Dude with a gokart, a MIG
Messages
88
Reaction score
4
Location
New Mexico (Not Dirty Poor Mexico, NO HABLA ESPANO
I would think the best thing to do would replace the piston too. U would have to look at the condition of the cylinder wall to see if u could get away with just honing the walls smooth. if ur finder nail catches then ur gonna need to overbore to appropriate oversize and get a oversized piston and rings. ie 10 over and etc. Do they make engine componants for that old of a motor? It might make more sense to just buy a newer motor if u can swing it.
 
Status
Not open for further replies.
Top