1 1/8 bore clutch

Status
Not open for further replies.

Moose4987

New member
Messages
3
Reaction score
1
Hello everyone,
I'm new to these forums, although Ive been lurking for the past couple weeks. I recently started taking apart an old lawnmower with a 20 hp kohler engine in it, and discovered it had an 1 1/8 inch shaft. I saw the sticky for the custom clutches, but i really didn't want to spend that much on the clutch alone.

Anyone know where I can find a clutch for 1 1/8 drive motors? I have access to a lathe if I need to do some boring myself. Thanks guys, I'm sure I'll have more questions as my build progress, and I'll try to help anyone if i can with my limited knowledge ;)
 

Jcotz

...wasn't there
Messages
374
Reaction score
1
Location
NY
Commercially available, it will be very hard to find a 1 1/8 clutch, or anything above that in order to lathe that down. The best bet would be to go with what you mentioned before, the custom clutch.
 

souperman000

New member
Messages
2,466
Reaction score
11
Location
Westlake Village, CA
If you have a lathe, Why not just lathe down the shaft, or make an adapter?

Here is an adapter I put on my engine, it is an adapter from 1 in to 5/8 in

 

Jcotz

...wasn't there
Messages
374
Reaction score
1
Location
NY
That is a good idea, I interpreted his use of a lathe as using it to bore out a larger clutch.
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
Another idea would be to start up the engine and file down the engine. But if you do this, you will have to put in another key-way.
 

Jcotz

...wasn't there
Messages
374
Reaction score
1
Location
NY
Another idea would be to start up the engine and file down the engine. But if you do this, you will have to put in another key-way.

Some have done that with success, others have ruined their crank and/or engine. Know what you are getting into if you try that.
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
They make 1 1/8" clutches for both torque conveters and centrifugal chain drive clutches. However if this is just a chain drive centrifugal clutch the jackshaft idea is the cheapest.
 

Moose4987

New member
Messages
3
Reaction score
1
hmmmm thanks guys! i never thought of the adapter idea, and it doesnt look too difficult. the jackshaft is interesting too, I really appreciate the help.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Why not just remove the crank and lathe it down? Then fit a 1" centrifugal clutch or torque converter? Am I missing something?
 

Moose4987

New member
Messages
3
Reaction score
1
well i thought about that, but I'm not sure I'm comfortable risking messing the crank up, and I'm a little worried about lathing a shaft with a keyway already in it.
 
Status
Not open for further replies.
Top