Search results

Does anyone know where you can buy a valve spring compressor that will work on Honda or Clone engines? The ones I've seen for sale won't fit around the head properly. I've ran a quick search of this forum and all I saw was homemade ones. I rather buy one if I can find one cheap. 18lb springs...

I was reading some articles today on the internet about engine modifications. Someone recommended using a different oil than the manufacturer's recommendation if you have removed the governor and are running the engine at high RPM. Their thoughts were the engine was running twice as fast, so...

Now that I took my governor out, when I get up close to 30 mph when driving in the grass, the whole go-kart starts to bounce (almost at a harmonic frequency). It gets so bad after about 5-10 seconds that my foot bounces of the gas pedal. I don't have a suspension at all. I am currently...

I have a Honda GX200 (not a clone) governor removed 18lb valve springs high flow single stage exhaust header with muffler UNI high flow air intake .625" bored carb with #92 main jet ARC billet connecting rod 8 degree advance timing indexed spark plug adjusted spark plug gap to 0.045" I do have...

I'm installing a uni air filter on a Honda gx200. What do I do with the tube that went from the valve cover to the stock air filter housing?

I'm going to be installing a billet rod in my 6.5 HP Honda GX200 this weekend. I need to remove the oil sensor. Affordablegokarts.com recommends plugging the whole with a 3/8" x 1" bolt and copper washer. They don't carry copper washers at the big bog Home Depot type stores, and even...

I'm currently running a 6.5 HP Honda GX200 (governed at 3600 rpm)with a torque converter and a jack shaft. There is a 10 tooth sprocket on the jack shaft and a 72 tooth sprocket on the axle, and 20" diameter rear tires. (see picture below) I'm assuming when the kart is at top speed the torque...

I'm looking to get some new knobby front tires for my old go-kart. (Picture attached below) The ones that are on it now don't hold air and have very little grip on grass. (yes I've tried to seal them with the slime stuff, but no luck) The tires on it now are tubeless size 15x6.00-6. I'm having...