Search results

I raised the float to a perfect Parallel still having the same problem. The engine stalls when I turn off the choke. But lowering the choke slows down the back tire spinning. Just that at a certain point of putting the choke off it starts to stall out.

Ok, also the cap and the spring I didn't take a picture of but I do have both

I'll have the pictures to you soon, Also I did check the float levels they where parallel level. But I couldn't find the right measurements online for float height for the VM22 clone mikuni.

What places specifically should I take pictures? I don't want to post wrong pictures that have no involvement in what may be going on.

The spring is there. The slide moves up and all the way down freely. Slide Doesn't get hung up. I've adjusted the mixture screw to 1 / 5 turns put from all the way in adjusted from there when the bike was warm. The trottle cable was properly set in I even took it out to see if it was but same...

I've tried even turning it out to the point where it was gonna fall out to see what would change. But still not much change

There seemed to have been an leak where the manifold meets both the head and the other side the carb before, I actually got a better gasket for the head side and for the carb side I lined it up with the o ring perfect and additionally sealed it. Then attached it. That fixed the problem with me...

I just need to figure out why the idle is so high that it's making the wheel speed and pretty fast. That's it atleast I hope... the idle screw doesn't seem to change the idle so I think it's a leak but I'm not 100% sure and if it is I don't know where... so if anyone has any other suggestions or...

There not very bad I just probably got the bad one and/or I'm not very knowledgeable about carbs

An air leak from where the idle screw is? If you could post a picture that would be very helpful. I don't think there is anymore leak from the manifold.

When the choke is on the back wheel has to be atleast spinning over or atleast 2500. But when I lower the choke it slows down alittle. When I fully turn off the choke even when warming the engine for couple minutes the engine dies. I could hold the brake to stop it but still is dangerous because...

I properly lined the carb up literally perfect I would say.. it does trottle now and doesn't cut out. But the back wheel still spins at high rpm

Also that fully fixed the problem or did you further tune the carb idle and air?

I was thinking It had to do with a leak in the manifold. When I get home I'll try my best to line them up if they aren't already. And respond back

Reminder I am using an aftermarket VM22 carburetor. The Carb has an idle set screw on the side which low/raise idle depending on which way you screw it out. I've tried lowering the idle with this screw and I didn't really make a difference in my main problem which would be the the bike...

I've very recently bought the Predator 224cc wanting to put it on my Minibike. Also buying a VM22 Carb and header for the 224 installing both. And mounting the engine on to the minibike. I should mention that I checked the Carb just incase it was dirty for some reason also changing the jet with...