Search results

  1. M

    Hysong 250 wire harness

    Hi, I'm after a wire harness diagram to suit a Hysong 250 V twin motor. I'm looking at fitting to my mini monster truck but unfortunately the harness we have has been partially cut up and not sure what goes where. Any help will be appreciated. Jason..
  2. M

    Harness

    Hey, I bought a 4 point harness off Aust Ebay for $50 delivered,I would be looking there cos my harness is good quality and approved safety.
  3. M

    Hi From Perth,Western Australia

    OI,OI,OI !!!! Hi, Not too shabby huh ! Took it to the sand drags on Saturday too see how fast it can go but unfortunately busted up the small bearing blocks holding the first chain axle.Not to worry get some more by end of week ready to go again. Also found out I got first place in the buggy...
  4. M

    The Rust Rocket

    Hi, Top stuff.....see anything can be made without the means of $$$$. Looking at your steering and just a thought, Some old boats came out with a push pull steering setup uterlising same sought of cable. The sleeve that slides onto your steering shaft and can be fixed by screws gets wrapped...
  5. M

    Hi From Perth,Western Australia

    Hi All, I'm new to the go kart/Buggy scene going for a change from quad bikes. Have just purchased a new toy and gave it a spruce up. My brother and I are looking at producing more of these as there is nothing like this here. Below is what we have..... Runs a 250cc Lifan quad motor with 4gear...
Top